Support end connector
The Irus support end connector serves to stabilise the ends of 2 boards/panels. This connector can also be used for supporting shelves. The connector can be attached at a desired height and the board/panel positioned on top. Counters and display cases permit optimum use.
|Clamping screw / or panel thicknesses||Item No.|
|Steel clamping screw / of 3-5 mm||00.007|
|Steel clamping screw / of 5-8 mm||00.107|
You might also be interested in
The Irus 90° connector is only used for rigid connections. The 90° connector is not movable. It is primarily used for corner connections and is a cost-favourable alternative to the angle connector.
Basic element type T
The basic element Type T is used as an end fitting for boards/panels. Ground unevenness can be compensated for by using the adjustable legs. Simply screw the adjustable leg in or out.
Middle connector 180°
The Irus middle connector is the simple solution for 180° connections. The central connector is not movable and can only be used for rigid connections.
The positive feature of the Irus multifunction connectors is that they have stepless adjustment from 0°-360°.
The Irus angle connector is a flexible connector for stepless adjustment between 90°-270°.
Foot adjustable M 6 x 30 mm
The adjustable foot compensates for unevenness of the floor.